How To Fix A Iphone 5s Charger Port

How to fix a broken charge port on an iPhone 5

If you're having trouble charging your iPhone 5, it's possible that either liquid came into contact with your charge port, or one of the pins are broken. Other symptoms of a bad dock connector can include iTunes not recognizing your iPhone when it's plugged into the computer. If you're experiencing any of these symptoms and aren't quite ready to fork over the cash for a new iPhone just yet, we can walk you through how to repair your iPhone on your own. Follow along for step by step instructions on replacing the Lightning dock in your iPhone 5!

What you need to DIY repair a broken dock connector in an iPhone 5

You'll need some tools and parts in order to repair your iPhone 5. iMore recommends using only quality and genuine parts from a reputable supplier like iFixYouri. They have quality parts, tools, and much more for all your repair needs.

Replacement dock connector
Suction cup
5-point security screwdriver
Standard #000 Phillips screwdriver
Spudger tool
Razor blade
iSesamo Opening tool

Step 1: Power off your iPhone 5

How to DIY replace a blown earpiece on an iPhone 5

Before beginning any repair, always power your iPhone down completely using the Slide to power off option. Easy enough right?

Step 2: Remove the front screen assembly

How to DIY replace a blown earpiece on an iPhone 5

Alternate method: If you're having issues pulling the screen up with a suction cup, you may insert a razor blade on the outer edge of either screw hold and pry upwards slightly. This method gives you enough clearance to stick your spudger tool underneath and release the screen. I recommend this method if your hands aren't as steady or you're afraid you may pull too hard and damage a cable.

Step 3: Remove the battery

I'll preface this section by saying the plastic battery tabs to pull to release them are useless. They break off and/or bend the battery. You can try that method but I suggest following my instructions below instead.

It is important while performing the steps above that you're careful to not puncture or bend the battery. Just take your time and you'll get there. Don't rush and don't force it.

Step 4: Remove the Lightning dock connector assembly

Step 5: Separate the loud speaker assembly from the dock assembly

The loud speaker assembly is attached to the dock assembly by a single cable. The only thing connecting it is a bit of adhesive. Use your spudger tool to separate the speaker from the dock at the point shown in the photo below.
Now place the loud speaker assembly on the new dock connector assembly. Take care to pay attention to the orientation of the contact point so you know you're putting it on correctly.

Step 6: Replace the dock connector assembly

Step 7: Replace the battery

Carefully lay the battery back down into place. Press firmly in order to cause the adhesive to grab hold of the back casing again.
Reconnect the battery connector by carefully lining it up and pressing firmly with your finger.
Reposition the battery shield and use your #000 screwdriver to replace the two screws.

Step 8: Reconnect the display assembly

Step 9: Test the new dock assembly

Now that your iPhone 5 is fully assembled again, it's safe to power it back on. Once it boots back up, connect it to a wall charger to make sure it charges okay. Do the same in a computer to make sure iTunes recognizes your iPhone 5. I also recommend making sure that when your iPhone 5 is plugged in, it isn't getting any hotter than it normally does during charging. If it does, it could be a faulty dock and you should request a replacement from the supplier immediately.

If you run into problems, be sure to check out our iMore mod forums for answers to commonly asked questions.